Support – manuals, videos and FAQ
Manuals, installation and service videos, answers to common questions and spare parts for Nira pumps.
Manuals
Fuel, oil & chemical hand pumps
Cold-weather hand pumps
Hand pumps for wells
Playground water pumps
Can’t find your manual? Ask us.
Videos
Installation
Nira 6B installation
Nira 6B hand pumpInstalling the Nira 67 well pump
Nira 67 well pumpNira 67 playground pump
Nira 67 playground pump
Service
Disassembly of the pump
Nira 6B hand pumpChanging the flange gasket
Nira 6B hand pumpChanging the handle grip
Nira 6B hand pumpChanging the shaft seal
Nira 6B hand pumpInstalling the suction valves, valve housing and flange gasket
Nira 6B hand pumpChanging the plunger seals and cylinder seals
Nira 6B hand pump
FAQ
Do Nira pumps need electricity?
No. All Nira pumps are operated manually with a lever.
Can the pump be used for drinking water?
Nira well pumps (Nira 67, Nira 3B and Nira 1 Antique) are suitable for pumping drinking water. Nira 2, Nira 6B and Nira 9 hand pumps are not, because water remains inside them after use.
How deep can the Nira 6B and Nira 9 lift liquid?
The suction height is 4 m without a bottom valve and 8 m with a bottom valve. As a rule of thumb, 10 m of horizontal suction pipe reduces the suction height by about 1 m.
Will the pump freeze?
If you pump water, empty the pump completely before the temperature drops below 0 °C: disconnect the suction pipe and pump until the pump is dry. Also empty the suction pipe. The frost resistance of the seals depends on the seal material and the liquid.
Can the lever point downwards?
Yes. The Nira 6B is available with the lever up or down. The direction is chosen when ordering and cannot be changed afterwards.
Does the hand pump prevent siphoning?
No. If the end of the outlet hose is left below the liquid level in the tank, liquid can keep flowing out. For the Nira 6B an anti-siphon kit is available as a retrofit.
Does the pump need annual maintenance?
No. If the pump is used for water, empty it before freezing temperatures. All parts are available as spare parts.
Are spare parts available for old pumps?
Yes. Spare parts are available for almost all Nira pumps with rubber seals, including seal kits for pumps made before 1989.
Do Nira well pumps freeze?
No, when installed correctly. The cylinder must be below the frost line (approx. 2 m below ground) and the drain hole in the riser pipe above the cylinder must be open so that water can drain out.
How large a hole is needed in the well cover?
100 mm. The cylinder diameter is 90 mm and the base flange diameter is 22 cm.
Do Nira well pumps create pressure?
The Nira 67 develops approx. 1 bar, so you can connect a garden hose and move water further or uphill. The Nira 3B and Nira 1 Antique do not create pressure.
Which thread is at the bottom of the well pump cylinder?
Plastic cylinders have a 1¼" internal thread. Older pumps with a brass cylinder have an R1½" thread.
Where are Nira pumps made?
In Sastamala, Finland. We have our own foundry and manufacture the pumps ourselves from start to finish.
Spare parts
Exploded-view drawings for every Nira pump model – find the part you need and ask us for a quote.
Need help with your pump?
Tell us your pump model and what you need. We’ll help you.
Phone +358 10 830 6759 · Email nira.info@nira.fi







